KINMAX SOURCE INTERNATIONAL CORP.

The Foam Foaming Machine CFM-01A uses the hand pouring process. The mixing bar is moved down manually to the lowest position during mixing and moved up to the highest position while mixing is ready. The mixing speed can be adjusted from 300rpm to 4200rpm. There are two units of mixing timer control.

> Including two stainless mixing tanks
> Floor Space : 160 x 150 x 300 cm (LxWxH)
> Motor : 15Hp x 1
> Capacity : one block / 6-8 minutes

The CFM-01B is same as CFM-01A, except of its mixing
method. The mixing propeller is fixed at the bottom of
mixing tank, the mixing principle is similiar to the fruit
juice mixer. Therefore, less air comes into the chemical
stream during the mixing which involves simple
operation and high working efficiency.

> Including two stainless mixing tanks.
> Floor Space : 135 x 120 x 130 cm (LxWxH)
> Motor : 15Hp x 1
> Capacity : one block / 6-8minutes

A. Square Moulding Tank (方型模)

Square foam blocks can be produced by square moulding tank for horizontal or vertical cutting.
The size of square moulding tank can be adjusted according to your specification.

> Dimension : 320 x 182 x 120 cm (LxWxH)

B. Round Moulding Tank (圓型模)

    Round foam blocks can be produced by round
    moulding tank for peeling machine peeled.

    > Dimension : 152cm x 152cm (H)
    > Remarks : other specifications can be offered on
                            request.