TIN CAN  MACHINE EQUIPMENT      
                                                                                                                                                      Index
      Page  1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11.


        S-B18G(5)  AUTOMATIC STRIP FEED PRESS 自動沖床機        

 

　

Specification

　S-B18G(5) Automatic Strip Feed Press is built not only for two piece can drawing but also for five gallon end stamping.  Piled strips are lifted by a hydraulic cylinder then suck pads send strip one by one to strip feeding station.
Reciprocating feeding bar at feeding station send strip into punch tooling. Formed can body or end is ejected out via. air blowing to rear while strip scrap is ejected out by a pressing roller to side.  Punch tooling is made of alloy steel; hence, sturdy for long life. An automatic greasing pump and multiple safety devices are equipped for easy maintenance and safe operation.
　
    機　  　型　　        MACHINE TYPE S-B18G S-B18G5
 適用罐蓋直徑            Range of end (or can) dia. 211~401 D x 56 mm H 5 GAL End
 每 分 鐘 產 能            Capacity per minute Up to 100 CPM Up to 60 EPM
 需   要  馬  力             Horse power required

10HP x 1 , 1HP x 1 , 1/4HP x 2
 需要壓縮空氣            Compressed air required

120L/min. x 5Kg/cm2
 適用鐵皮長度            Range of strip length 510~950 mmL
 適用鐵皮寬度            Range of strip with 128~260 mmW
 淨                重            Net weight (approx.) 5200 Kgs
安裝面積及高度         Floor space overall height  3610L x 2500W x 1850H mm 3810L x 2500W x 1850H mm

FEATURES

　

  • Strip lifting by hydraulic cylinder and use proximity switch for strips height control.

  • With duplex switch for machine starting, safe and reliable.

  • With air clutch for power transmission, effective but low maintenance.

  • Multi-safety desing for machine and personnel safety.

  • Easy for can size changeover and adjust.

  • Can link with auto strip feeder S-B-18-2 for labor cost saving.

  

        Page  1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11.                                  Top